DocsSettings
Impact settings
The Impact tab in Settings holds the values Impact uses to decide what needs attention. You can set them for all repositories or for one.
Open the tab
Press ⌘, or choose Whaatcher › Settings…, then click Impact.
Each value has a number field and stepper arrows. Click its ⓘ to see what it decides and why its default was chosen.
A change applies right away, and panels already open in Graph refill their Impact with it. There's no Apply button. A value outside its range is cut to the nearest end.
Choose where values apply
Values for at the top picks All Repositories or a single repository. A repository uses the value set for it first, then the all-repositories value, then the default.
With All Repositories chosen, the line under each value shows its default, such as Default: 10%. With a repository chosen, a value you haven't set for it reads Same as all repositories. Once you change it, the line shows the all-repositories value, such as All repositories: 10%, and the repository's name in Values for gains (own values).
Changing an all-repositories value leaves repository values as they are. Setting a value to the one it would inherit removes it, so it follows later changes again.
Compared with this repo's usual
- Flagged top share (default 10%, range 1–50%): size, spread, long-untouched files and repetition are flagged when they fall in this top share of recent commits. Raise it to flag more, lower it to flag only the rarest. Size is marked on the summary line, the rest under Needs attention.
- Commits for the usual (default 500, range 100–1,500): how many of the latest commits make up the usual.
- Earlier commits compared (default 500, range 50–1,500): each change is compared with up to this many commits before it. A file unchanged within them is long-untouched.
- Fewest earlier commits (default 100, range 10–1,000): with fewer earlier commits than this, or fewer commits in the usual, Impact says it can't compare. In use, it never exceeds the two counts above.
Spread
These two decide which folders spread counts. Impact explains spread itself.
- Folder changes for spread (default 5, range 1–50): only folders changed at least this many times in the earlier commits count.
- Hub folder share (default 20%, range 5–100%): folders changed in more than this share of the earlier commits are left out, since they change with everything. At 100%, none is left out.
Co-changed files and tests
- Co-change rate counted (default 80%, range 40–100%): a usually co-changed file left out of a change can go under Needs attention only if the two changed together at least this often. Below it, the file stays under As Usual.
- Commits that change tests (default 90%, range 0–100%): a code change without test changes goes under Needs attention only when at least this share of the repository's code commits also change tests. Otherwise it stays under As Usual. Lower it for a repository that changes tests less often.
Reset a value
With All Repositories chosen, a value you changed shows Reset to Default under it. With a repository chosen, a value set for that repository shows Use All Repositories' Value, which removes its own value. Values reset one at a time.